![sharper image burnout drift rc car sharper image burnout drift rc car](https://driftmission.com/wp-content/uploads/2016/04/Burnout-Demon-RC-Drift-Smoke-Generator-DriftMission-RC-Smokers-1-980x490.jpg)
![sharper image burnout drift rc car sharper image burnout drift rc car](https://i.ebayimg.com/images/g/J7MAAOSwxTxfHIw0/s-l640.jpg)
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.Increase the separation between the equipment and receiver.Reorient or relocate the receiving antenna.If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: However, there is no guarantee that interference will not occur in a particular installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference in a residential installation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device complies with Part 15 of the FCC Rules.
![sharper image burnout drift rc car sharper image burnout drift rc car](https://images-na.ssl-images-amazon.com/images/I/41HSA95bYuL.jpg)
Keep these instructions for future reference.Recycle or dispose of batteries according to federal, state, and local laws.Do not dispose of batteries in a fire, batteries may explode or leak.Do not short-circuit the battery supply terminals.Do not charge with non-rechargeable batteries.Always use, replace, and recharge (if applicable) batteries under adult supervision. Insert batteries using the correct polarity.Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.If the product appears worn, frayed/splintered, cracked, or broken in any manner, discontinue use and discard immediately. Thoroughly inspect products before every use.Adult supervision is recommended when operating the vehicle.Do not leave vehicle or transmitter near sources of heat or under direct sunlight for long periods of time.Keep fingers, hair and loose clothing away from wheels while vehicle is in motion.Never operate your vehicle in in climate weather, rain, or standing water.Do not use people or animals as obstacles.When the Burnout Drifter water tank is empty, the rear wheel red LED will flash during burnout to let you know you need to add more water.Please leave enough room (approximately 20 feet) in front of the vehicle. The vehicle will automatically accelerate forward with smoke effect. To perform a burnout, make sure the vehicle is stationary, then press the burnout mode button on the top left of the remote.Press the drift mode button again to exit drift mode. Push the throttle up and turn right or left to drift with smoke effect. The remote light will flash showing the vehicle is in Drift Mode. For a drifting turn, press the drift mode button on the top right of the remote.For normal turning, push the throttle up to go forward and the turning stick to the left or right depending on what direction you want to turn.The steering controls left and right turning. The throttle controls forward and reverse. Control the vehicle using the remote-control sticks.To turn the vehicle off, press and hold the power button on the bottom of the vehicle for 3 seconds. Turn the power knob on the remote clockwise and push the power button on the bottom of the vehicle to switch on.Carefully remove items from the package.Reclose the gasket and slide the reservoir door closed.Wipe any excess water with a dry clean towel. Gently squeeze the tank to dispense the water. Slowly fill the tank using the water container until full.Open the PVC gasket by gently pulling on the tab.Open the Burnout Drifter reservoir by sliding the door (with the water drop symbol) toward the rear of the vehicle.The water container cap and spout can be unscrewed by turning counter clockwise.